Car Dolly Snappin Turtle V4694 – Tow Vehicle Accessory

Each Jack has a rigid steel frame with 1500lbs each capacity or 6000lbs vehicle capacity when you use a full set of four jacks.All the lifting action is operated by a foot petal.

< li >Easily lift and re position your vehicle without touching the frame

< li >Move your vehicle in any direction.

< li >Use two jacks to permit a full 180 degree pivot

< li >Use 4 jacks to place your car a on a full 360 degree rolling platform.

< li >Jacks will handle tires up to 12 inch wide.

Operating Instructions:
1)Place jack on floor and press down on pedal to release pedal lock. Pull out the lock pin from frame
2)Before operating turn the release valve by turning counter clockwise. Expand jack by hand wheel enough to place jack around tire and position so both rollers now contact the tire tread. To obtain the best control of jack while expanding around tire, place your left hand on top of the left side axle and your right hand at the center of the pedal. Close release valve by turning hand wheel clockwise to a snug tight position, The jack can now be used.
3)Install jack so the unit is parallel to the side wall of the tire to be lifted. Leave approximately 3/4 inch of clearance between the tire and jack. This is very important. If the unit is misaligned it is possible that the tire will be forced to hit the axle of the jack and not the rollers, this may damage the jack and void the warranty.
4)To lift tire, lift directional lever up and place foot on pedal depressing with smooth even strokes. Cycle pedal until tire is lifted from the surface 1 inch or less. After lifting the lower the tire is to the ground the more stable the jack will be. After lifting always make sure the lock pin is in place before lifting the other tires.
5)To release jack, pull pin out from frame and open valve by turning hand wheel slowly counterclockwise. Jack may be moved when rollers disengage from tire.

WARNING: Cancer and Reproductive Harm